Shrink chuck 3° BT 40 - 06 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Screwdriver

end mills) to “zero” and for determining the reference point of the machine spindle

Plug gauge sizes according to DIN 2245

- Illuminated display with LCD display "0

- Without wrench

WrenchWarranty cardInstruction manualCalibration certificate

6 T-slot nuts

0V Battery

Tool steel

min-1) = 6000

A possible increase of axial force during the tapping process is reduced to a minimum

DCONWS = 6 to 18 with two coolant channels