Jubilee Crossbar by Mandala Rose WorksIn stock and ready to ship. The Jubliee crossbar by Mandala Rose Works is milled from 6061 Aluminum. This part is machined to Joshua Vasquez's specifications and assures a good drop in for the Jubilee. Specifications: Weight: 160 grams Length: 19 inches Height: 2 inches Thickness: 9mm Part #: 041 CRS 02 M61 MRW The specific build instructions are available here. If you are upgrading from a carbon fiber crossbar, you will need: 1x M3 10mm standoff 1x

E3D Hemera Creality Cr10s Pro by Daniel Rock

If you are looking to print with specialty filaments

Comes with a small probe and bare wires

Spec sheets / drawing available here

Thermistor cartridge

1x CAN Bus interface (MicroFit 3

E3D’s manufacturing capabilities have significantly increased over the years

0A rated current of this motor

Roto ready

5 additional extruder heater outputs

allowing you to change them out should you ever need to

75mm filament only