Carbide tips for brazing on turning tools1 Scope This International Standard specifies the dimensions of carbide tips for turning tools intended to be fixed on the shanks of tools by brazing. NOTE Throwaway carbide indexable inserts are the subject of ISO 883.

and typically constitutes further restrictions on parameter values

Why should you use BS 3087-1 – Pliers and nippers

An alternative method of removing the lubricant from the condom using an aqueous surfactant solution has been introduction into the method for determining the amount of lubricant on the condom

If unprotected

slope instability

Additional or divergent requirements for ships with nonmetallic hull will be given in a future International Standard (IEC 62742)

communication/network and packaging

2 Component definitions

maintained in a manner that provides a lockable self-contained storage space providing protection from the natural element

and impact area

Switching pictures: To enable switching between different coded streams and substitution of pictures within the same stream

With compliance and obedience to BS EN 60758