Milling arbors for screw-in cutters HSK 63 - M6 - 51 - LB25Application: For mounting screw in cutters with thread. Delivery: All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

With built-in tightening bolt

(applicable up to 21 bar)

With drivers

Delivery with test certificate All holders are made of forged steel

Improves chip evacuation and decreases the risk for chip jamming

Collection of collets

For the storage of collet chuck

For sealing the spindle of the turret

Thread confi guration with a special design

without cooling lubricant supply

HSS-Co5 Twist drill DIN338 d=6

bei Ø 6 – Ø 32 mm = h238