Shrink chuck 4,5° with cooling channels HSK 100 - 16 - 100Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

With built-in tightening bolt

Bed height H: 0

For the coolant supply through the centre of PSK toolholders

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance2

Ring gauge accuracy according to DIN 2250Delivery:

clamping depth = 41

Cone and flange hardened and grinded

From d = 25 on two clamping screws

Rotary holder for clamp holders with coolant supply directly to the cutting edge and for ISO clamp holders with claw clamping for optimum cooling of the cutting edge

Thread configuration with a special design

without cooling lubricant supply

DCONWS = 6 to 18 with two coolant channels