Resistance spot-, projection- and seam-welding. Method for determining the transition resistance on aluminium and steel material1 Scope This International Standard specifies the procedure and the experimental set up for determining the transition resistance of a single sheet or two overlapping sheets of aluminium or steel, with or without surface treatment, and with or without surface coating.

BS 7000-1 also complements BS EN ISO 9001

c) System integrity (SI)

EN 12586:2007

all forms of energy and uses of energy

What is BS EN 13248 - Requirements and test methods for coffee makers about

BS 5306-1 provides guidance in protecting installed equipment from theft and vandalism

tests and requirements for sealed nickelcadmium prismatic secondary single cells

caused by impacts or abrasion

b) it can be used as a control test to determine the effectiveness of the various processing steps including pre- and post-baking treatments to reduce the mobile hydrogen in the articles or rod

Sponsored by the Institute of Civil Engineers

Information common to both measurements is contained in clauses 1 to 8

The test levels in BS EN 50470‑2 are regarded as minimum values to guarantee the proper functioning of the electromechanical meter under normal working conditions