Petroleum and related products from natural or synthetic sources. Determination of cloud point1 Scope This document specifies a method for the determination of the cloud point of petroleum products which are transparent in layers 40 mm in thickness and have a cloud point below 49 C, amongst which are diesel fuels with up to 30 % (V V) of fatty acid methyl ester (FAME)[2], paraffinic diesel fuels with up to 7 % (V V) FAME[3], 100 % FAME[5] and lubricants. NOTE For the purposes of this document, the term % (V V) is used to represent the volume

PD 5304 discusses the safe use of machinery

to identify any gaps that occur over time

For flow observed at the time of determining gauge heights from a series of gauges

They are typically found where large loads are required

1   Product definition

Manufacturers of aerospace products

PD CLC/TS 50625-3-1 is intended to be used in conjunction with EN 506251 for most types of WEEE (other documents will be developed to define requirements for specific WEEE requiring more specialised treatment)

It applies to metric depth gauges that measure from zero up to 600 mm using a main scale and vernier scale graduated to read to 0

you can minimise the friction level of rail frictions and wheels

BS 4873 is applicable to the following window types

as received for testing

The catastrophic failure modes arising and which are described in this document in general occur at bending radii much smaller than specified in the single-mode fibre specification IEC 60793‑2‑50 or than would be recommended based on mechanical reliability considerations alone