Fibre-reinforced plastics. Methods of producing test plates - Filament winding1 Scope This part of ISO 1268 specifies a method of preparing reinforced plastic test plates by the filament winding process, using textile glass rovings and themoset resins (preimpregnated fibres are excluded). It specifies the preparation, under optimum industrial conditions, of unidirectionally reinforced plates, from which test specimens for various static mechanical tests can be cut. This part of ISO 1268 has been established for glass reinforced

BS EN 455-1:2000

Detection methods

6 Performance

BS EN ISO/IEC 17021:2011 helps with the certification of an organization’s management systems

when much measurement data has been obtained

As these metals are often difficult to solder due to the tough oxide layer present on the surface of the steel alloys

or a subset

reliable products that meet or exceed customer and applicable statutory and regulatory requirements to assure customer satisfaction

standard width of the strips and standard core size

could undergo during handling and is normally restricted to two falls from a prescribed attitude onto a specified surface from a specified height

coated flat products

Some of the tests are intended for use in obtaining assurance that material complies with British Standard or other requirements