DS1402-RPL+ 20 Ft. CableThe DS1402 RPL+ cable is used to connect iButtons to 1 Wire masters, such as the LinkUSB. This cable is 20 ft long when uncoiled, which is indicated by the RPL+ in the product name. One end of the cable can be used as either a dwelled or momentary contact for an iButton in order to read information off of the iButton. The other end of the cable is a modular connector for the 1 Wire master. Visit the DS1402 RPL data sheet for more information on this

Calibrated iButtons are tested by our in-house

comparison-chart { width: 100%

water-resistant device is great for use in cold chain shipments or in other applications where keeping a close eye on temperature is important

padding: 10px 14px

The SS-WALL-C-TH does not mask error conditions

Easy to set up and use

The box holding the electronics is shipped with 3 feet of 18-gauge wire extending from it

values: '122K (8-bit) or 61K (16-bit)'

The response time in slow-moving air is typically 30 seconds

please refer to the LinkLocator manual

Approximate response and recovery times of the DS18B20 sensors can be found in Appendix One of the T-Sense manual

including the reader and a 6 ft USB cable