Tool holders with rectangular shank for indexable inserts - Style L1 Scope This part of ISO 5610 specifies tool holders with rectangular shank, style L, i. e. with offset shank and cutting edge angle r = 95 for side and end cutting. These tool holders are primarily intended for indexable inserts made of hard metal or other cutting materials to be mounted by clamping and to be used for turning operations. NOTE The symbols for the dimensions shown in the tables of this part of ISO 5610 and the corresponding preferred

The electrical equipment covered by this document commences at the point of connection of the supply to the electrical equipment of the machine

interregional studies and other methods in order to ensure their IPS is constantly updated/enhanced and maintained

it can also be applied to systems that can utilize water mains and/or electricity

balancing of pulleys

during manufacture or for the requirements of this test

BS EN 12517-2 assumes that the radiographic testing has been carried out in accordance with BS EN 1435

This part of ISO 17234 is supplementary to ISO 17234-1 and describes a special procedure to detect the use of certain azo colorants in commodities

and use of static vacuum insulated cryogenic vessels to ensure minimum risk of accidents while transporting liquefied elements

Plastics product manufacturers

The dimensions and methods provided by BS EN 60843-4 assist you in improving the performance and quality of the helical-scan digital video cassette recording system

What is BS EN 4127 about

NOTE Where the term "slate" is used in this document it means slate and carbonate slate unless otherwise indicated