End mill holder Weldon with cooling channels SK 40 - 12 - 50Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw and O ring All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Perforated plate for mounting accessories

clamping depth = 41

shank form UF

- not waterproof

For mounting straight-shank tools in collet chucks ISO 15488 (ex

Dial Graduation: 1°

Test certificate

- Calibration certificate

Made of sturdy grey cast iron with hollow profile handles and specially guided prismatic steel jaws

in conjunction with „KEMMLER Precision collet chuck ER"

One turning toolholder - four possibilities:

For mounting tools with Morse taper shanks