Petroleum and related products. Precision of measurement methods and results - Monitoring and verification of published precision data in relation to methods of test1 Scope This document specifies the methodology for the regular monitoring of the test method precision achieved versus the precision published in the standard test method using data from proficiency testing schemes (PTSs) supported by the regular users of standard test methods. The procedures in this document are designed specifically for proficiency testing (PT) conducted on standard test methods, having a published reproducibility, for petroleum

Association of Chief Police Officers (ACPO)

Section 3: Special series (UNS)

and exporters of sawn timber

This document specifies the standard test procedures and conditions for basic characteristics of lithium-ion cells for use in propulsion of battery and hybrid electric vehicles

BS 3900-E6:2007 Paints and varnishes

Additional requirements for the installation of fire/back boilers and fire/back circulators are specified in Clauses 15

but by authorized national or regional bodies

BS EN 14597:2012 includes some technical changes with respect to BS EN 14597:2005

test number - General -1 512-1   Applicable publications -1-100 none           Part 1: General examination     1a Visual examination -1-1 -2 test 1a 1b Examination of dimension and mass -1-2 -2 test 1b 1c Electrical engagement length -1-3 -2 test 1c 1d (With corrigendum) Contact protection effectiveness (scoop-proof) -1-4 none           Part 2: Electrical continuity and contact resistance tests     2a Contact resistance - Millivolt level method -2-1 -2 test 2a 2b Contact resistance - Specified test current method -2-2 -2 test 2b 2c Contact resistance variation -2-3 -2 test 2c 2d (Vacant)     2e Contact disturbance -2-5 -2 test 2e 2f Housing (shell) electrical continuity -2-6 -2 test 2f 2g (Vacant)               Part 3: Insulation tests     3a Insulation resistance -3-1 -2 test 3a           Part 4: Voltage stress tests     4a Voltage proof -4-1 -2 test 4a 4b Partial discharge -4-2 -2 test 4b 4c Voltage proof of pre-insulated crimp barrels -4-3 -2 test 4c           Part 5: Current-carrying capacity tests     5a Temperature rise -5-1 -3 test 5a 5b Current-temperature derating -5-2 -3 test 5b           Part 6: Dynamic stress tests     6a Acceleration

These parameters are not the only ones to be considered when a lubricant has to be selected

activation or suppression is considered beyond the scope of this document

Why should you use BS 3409-2 – Specifications for tapped holes