End mill holder Weldon SK 40 - 12 - 50Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Water and dust resistant design

Carbide tipped scriber with clampWarranty cardInstruction manualCalibration certificateLR44 1

Conforms to the IP67 ratings

Flatness tolerance 0

Battery :1

With built-in tightening bolt All holders are made of forged steel

- Clamping accuracy at the centre 0

For setting tools (e

For longitudinal and plane turning

Magnifying glass is provided for easier reading

5V Battery

slim design (reduced interference contour)